Channel & Angle Section Posts

Ancon WP2 Windposts

Ancon WP2 Windposts are angle section windposts designed for either small cavities or where wind loads are high. One leg of the angle windpost is built into the blockwork, and the blockwork tied through the leg of the windpost to minimise any possible movement or cracking of internal finishes. If a vertical movement joint is required in place of a tied joint, ties with a plain end on one side can be supplied.

Ancon WP4 Windposts

Ancon WP4 Windposts are generally used in internal blockwork walls that have a 'fair faced' finish to both sides and where the windposts cannot protrude beyond either face. Sometimes referred to as 'spine' posts they are flat plates designed to fit within the wall. Although the depth of a WP4 post is limited by the width of the masonry (ideally 20mm less than the wall width) the thickness of the post can vary to increase its load capacity. Blockwork is tied through the post. Debonded ties can be used if the post is positioned at a movement joint.

Details for Specification and Ordering

The following clause can be adapted for your bill of quantities to aid the specification of Ancon Windposts and Parapet Posts.

Ancon Windposts WP2 130 x 70 x 6 in grade 304 stainless steel, overall length 2750mm complete with all ties and end connections. Fixed with Ancon FBN12/15 A4-115 Expansion Bolts.

Ancon Windposts are designed and manufactured to suit each individual project. Sufficient time should be allowed for the design, approval and manufacturing process when placing orders for windposts.

Windpost Design

Download the Windpost design sheet, complete and fax back on 03 376 5206 or email info.ancon.nz@leviat.com